Maintenance, Cleaning, Care And Adjustment - HomeMatic HM-WDS100-C6-O-2 Montage- Und Bedienungsanleitung

The device LED (J) lights up green to indicate that teaching-in has been
successful. If the device LED lights up red, teaching-in the device failed.
Please try again.
After a short time, the newly taught-in device appears in the inbox of your
user interface. The button "Inbox (x new devices)" indicates how many
new devices have been taught in successfully.
If required, you can teach-in additional devices by repeating the steps de-
scribed above for each device.
Now configure the newly taught-in devices in the inbox as described in
the next section "Configuring newly taught-in devices".
Configuring newly taught-in devices
Once you have taught-in your weather data sensor to the Homematic
Central Control Unit, it will be moved to the inbox. Here, you must config-
ure the device and its associated channels in order to make them avail-
able for operating and configuration tasks. Give the device a name and
assign it to a room. You can also make individual parameter settings.
Now you can use the "WebUI" user interface to control your device, con-
figure it, connect it directly to other devices, or use it in central control
unit programs. Please refer to the Homematic WebUI Manual for more
details (you can find this in the "Downloads" area of the website
www.homematic.com).
6

Maintenance, cleaning, care and adjustment

This product does not require you to carry out any maintenance
other than replacing the battery or cleaning the device when
necessary. Enlist the help of an expert to carry out any mainte-
nance or repairs.
The weather data sensor will need to be cleaned from time to time to
remove the dirt that will accumulate on it. When you do this, you should
also check that the wind sensors can move easily and that the sensors
are properly seated on their supports.
Maintenance, cleaning, care and adjustment
49