Teaching-In To The Homematic Central Control Unit - HomeMatic HM-WDS100-C6-O-2 Montage- Und Bedienungsanleitung

5.3.2 Teaching-in to the Homematic Central Control Unit

Please read this entire section before starting the teach-in proce-
dure!
Your device can be conveniently
controlled and configured,
•
• connected directly to other devices or
• used in the Central Control Unit programs
by using the Homematic software "WebUI". Therefore, your weather data
sensor has to be taught-in to the Homematic Central Control Unit first.
New devices are taught-in to the CCU via the Homematic "WebUI".
As soon as a device has been taught-in to a Central Control Unit,
it can only be connected to other components via this unit.
Each device can only be taught-in to one central control unit.
During teach-in, please make sure you maintain a distance of at
least 50 cm between the Homematic devices and the central
control unit.
To teach-in your device to the Central Control Unit, proceed as follows:
• Open the "WebUI" user interface in your browser.
• Click the "Teach-in devices" button on the upper right-hand side of
the screen.
Start-up
47