Operation; Stand-Alone Operation; Master/Slave-Operation; Dmx-Controlled Operation - EuroLite LED MFX-1 Bedienungsanleitung

OPERATION

After you connected the effect to the mains, the LED MFX-1 starts running. During the Reset, the motors are
trimmed and the device is ready for use afterwards.

Stand-alone operation

In the Stand-alone mode, the LED MFX-1 can be used without controller.
Disconnect the LED MFX-1 from the controller and call the internal program. Please refer to the instructions
under Control Board.

Master/Slave-operation

The master/slave-operation enables that several devices can be synchronized and controlled by one master-
device.
On the rear panel of the LED MFX-1 you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which
can be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master device and controls all
other slave devices, which are to be connected to the master device via a DMX cable. Connect the DMX
OUT jack with the DMX IN plug of the next device.
Set the desired Master-mode - „Auto" or „Soun", for the master-device, as described in chapter Control
Board. Set the DMX address 001 for all slave-devices.

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED MFX-1 will respond to the controller.
If you set, for example, the address to channel 17, the device will use the channel 17 to 32 for control.
Please, be sure that you don't have any overlapping channels in order to control each LED MFX-1 correctly
and independently from any other fixture on the DMX-chain.
If several LED MFX-1 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
MFX-1 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If there is
data received at the DMX-input, a dot will flash on the display. If there is no data received, the dot will not
flash.
This situation can occur if:
- the XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
26/31 00096242, Version 1.0