Operation; Stand Alone Operation; Master/Slave Operation; Dmx-Controlled Operation - EuroLite LED TMH-50 Moving-Head Wash Bedienungsanleitung

OPERATION

With the power switch, you can switch the device on and off.
After you connected the effect to the mains, the LED TMH-50 starts running. During the Reset, the motors
are trimmed and the device is ready for use afterwards.

Stand Alone operation

In the Stand Alone mode, the LED TMH-50 can be used without controller.
Disconnect the LED TMH-50 from the controller and call the internal program. Please refer to the instructions
under Control Board.

Master/Slave operation

The master/slave operation enables that several devices can be synchronized and controlled by one master-
device.
On the side panel of the device you can find an XLR-jack (DMX Out) and an XLR-plug (DMX In), which can
be used for connecting several devices.
Choose the device which is to control the effects. This device then works as master-device and controls all
other slave-devices, which are to be connected to the master-device via a balanced microphone lead.
Connect the DMX OUT-jack with the DMX IN-plug of the next device.
Set the desired Master-mode - „Automatic program mode" or „Sound controlled mode" - for the master-
device. Set the DMX address 1 for all slave-devices. Please refer to the instructions under Control Board.

DMX-controlled operation

You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-50 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-50 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-50 are addressed similarly, they will work synchronically.
If you set, for example, the address to channel 13, the device will use the channel 13 to 24 for control.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, four little stars will be flashing next to the display "DMX512 Mode". If there is no data received at
the DMX-input, the little stars do not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
23/27 00065136.DOC, Version 1.0