Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
DMX-controlled operation
You can control the projectors individually via your DMX-controller.
Every DMX-channel has a different occupation with different features. The individual channels and their
features are listed under DMX-protocol.
Addressing
The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-20 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-20 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-20 are addressed similarly, they will work synchronically.
The device has two different DMX channel modes (see chapter DMX protocol)
If you set, for example, the address to channel 17, the device will use the channel 17 to 32 for control.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the DMX indicator will be flashing. If there is no data received at the DMX-input, the DMX
indicator does not light up.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.
DMX protocol
The device has two different DMX channel modes. The Control Board allows you to assign the DMX channel
mode.
16 channel mode
Control-channel 1 - Horizontal movement (PAN) (within 630°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (TILT) (within 340°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - PAN/TILT-speed
Decimal Hexad. Percentage
0 255
00 FF
0% 100%
Control-channel 4 - Dimmer intensity - side 1 (RGB)
Decimal Hexad. Percentage
0 255
00 FF
0% 100%
Control-channel 5 - Red
Decimal Hexad. Percentage
0 255
00 FF
0% 100%
Control-channel 6 - Green
Decimal Hexad. Percentage
0 255
00 FF
0% 100%
S/F Feature
F
Decreasing speed
S/F Feature
F
Gradual adjustment of the dimmer intensity from 0 to 100 %
S/F Feature
S
Red (0=off, 255=100% red)
S/F Feature
S
Green (0=off, 255=100% green)
27/32
00064736.DOC, Version 1.1
Werbung
Inhaltsverzeichnis
