Addressing; Dmx-Protocol - EuroLite LED TMH-C3 Bedienungsanleitung

Addressing

The Control Board allows you to assign the DMX starting address, which is defined as the first channel from
which the LED TMH-C3 will respond to the controller.
Please, be sure that you don't have any overlapping channels in order to control each LED TMH-C3 correctly
and independently from any other fixture on the DMX-chain.
If several LED TMH-C3 are addressed similarly, they will work synchronically.
Press the Up/Down-buttons for setting the desired starting address. Now you can start operating the LED
TMH-C3 via your lighting controller.
Note:
After switching on, the device will automatically detect whether DMX 512 data is received or not. If the data
is received, the the display will show "A001." with the actually set address. If there is no data received at the
DMX-input, the display will show "A001" with the actually set address.
This situation can occur if:
- the 3 PIN XLR plug (cable with DMX signal from controller) is not connected with the input of the device.
- the controller is switched off or defective, if the cable or connector is defective or the signal wires are swap
in the input connector.
Note:
It's necessary to insert the XLR termination plug (with 120 Ohm) in the last device in the link in order to
ensure proper transmission on the DMX data link.

DMX-protocol

Control-channel 1 - Horizontal movement (PAN) (within 540°)
Push slider up in order to move the head horizontally (PAN).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 2 - Vertical movement (TILT) (within 270°)
Push slider up in order to move the head vertically (TILT).
Gradual head adjustment from one end of the slider to the other (0-255, 128-center).
The head can be stopped at any position you wish.
Control-channel 3 - PAN/TILT-speed
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 4 - Red
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 5 - Green
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
Control-channel 6 - Blue
Decimal Hexad. Percentage
0 255 00 FF 0% 100%
S/F
F Decreasing speed
S/F
S Red (0=off, 255=100% red)
S/F
S Green (0=off, 255=100% green)
S/F
S Blue (0=off, 255=100% blue)
24/28
Feature
Feature
Feature
Feature
00085700.DOC, Version 1.1