How To Replace The Airclean Filter; How To Replace An Active Airclean 50 Filter Or A Hepa Airclean 50 Filter; Replacing One Type Of Exhaust Filter With Another; When To Change The Thread Lifters - Miele Complete C2 Gebrauchsanweisung

en

How to replace the AirClean filter

(dia. 31 + 32)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Release the filter grille and raise it
upwards. Grasp the used AirClean
filter by the clean, unsoiled section
(see arrow) and take it out.
^ Replace it with a new AirClean filter.
If you wish to fit an Active AirClean 50
filter or a HEPA AirClean 50 filter
please see "Replacing one type of
exhaust filter with another".
^ Close the filter grille.
^ Close the dust compartment lid.
How to replace an Active AirClean 50
filter or a HEPA AirClean 50 filter
(dia. 33 + 34)
Do not use more than one exhaust
filter at a time.
^ Open the dust compartment lid.
^ Lift the exhaust filter and remove it.
^ Insert a new exhaust filter making it
sure it goes in properly, then push it
down into position.
^ Press the exhaust filter change
indicator ~ (dia. 13).
^ After approx. 10 - 15 seconds a thin
red stripe will appear in the left hand
side of the display (dia. 14).
38
If you wish to fit an AirClean filter,
see "Replacing one type of exhaust
filter with another".
^ Close the dust compartment lid.
Replacing one type of exhaust filter
with another
Depending on model, your vacuum clea-
ner will be fitted as standard with one of
the following exhaust filters (dia. 10):
a AirClean
b Active AirClean 50 (black)
c HEPA AirClean 50 (white)
When changing the filter please note:
1. If you wish to replace exhaust filter a
with filter b or c, it is essential that you
remove the filter grille before fitting the
new type of filter (dia. 34).
You will also need to press the exhaust
filter change indicator (dia. 13).
2. If you wish to replace exhaust filter b
or c with filter a, it is essential that you
also fit the filter grille * (dia. 32).
* Filter grille - see "Optional
accessories".
Do not use more than one exhaust
filter at a time.

When to change the thread lifters

The thread lifters on the suction inlet to
the floorhead can be replaced.
Check them from time to time and
replace them if the pile has worn down.