Running-In - MOTO GUZZI California Classic Handbuch

RUNNING-IN

The recommendations below should be followed when
running-in:
n Before riding, run the engine at low revs until it has
warmed up.
n Do not exceed the rpm shown in the table; it is also
advisable to run the engine at varying speeds rather
than at a constant speed.
n Before stopping reduce the speed gradually to
avoid subjecting components to sudden changes in
temperature.
n Ride carefully for the first 100 km (62 miles) to
allow proper bedding of brake pads. Avoid sudden
braking.
n Remember that components need several thousand
kilometers before they are properly bedded in; care
taken in this period will ensure prolonged vehicle life.
BREAKING-IN RPM
Kilometers
From 0 to 1000
From 1000 to 2000
From 2000 to 4000
www.guzzitek.org - Revente Interdite - Revendita Vietata - Resaling Forbiden - Wiederverkauf Verboten
IMPORTANT
After the first 310/1000 mi (500/1500
km) have the motorcycle controlled by an
authorized MOTO GUZZI dealer as specified under
«1000 mi (1500 km)» in «MAINTENANCE
SCHEDULE» on page 145 so to avoid injuries to
rider/other people and damages to the vehicle.
Should the oil level drop to the minimum
level before the first 500÷1500 kilometers
have been completed then carry out a complete oil
change rather than just topping up. Recommended
oil: «Agip RACING 4T SAE 10W-60».
Max. RPM
5000
6000
Gradually increase rpm until maximum
permissible level is reached.
109