Troubleshooting - IKEA Skinande Bedienungsanleitung

ENGLISH
3
Clean the filter of
the inlet hose.
Cleaning the spray arms
Do not remove the spray arms. If the holes
in the spray arms are clogged, remove
remaining parts of soil with a thin pointed
object.

Troubleshooting

If the appliance does not start or it stops
during operation. Before you contact an
Authorised Service Centre, check if you can
solve the problem by yourself with the help
of the information in the table.
Problem and alarm code
You cannot activate the ap-
pliance.
The programme does not
start.
4
• Make sure that the mains plug is connected to the mains
socket.
• Make sure that there is no damaged fuse in the fuse box.
• Make sure that the appliance door is closed.
• If the delay start is set, cancel the setting or wait for the
end of the countdown.
• The appliance has started the procedure to recharge the
resin inside the water softener. The duration of the pro-
cedure is approximately 5 minutes.
External cleaning
• Clean the appliance with a moist soft
cloth.
• Only use neutral detergents.
• Do not use abrasive products, abrasive
cleaning pads or solvents.
Internal cleaning
• Carefully clean the appliance, including
the rubber gasket of the door, with a soft
moist cloth.
• If you regularly use short duration
programmes, these can leave deposits of
grease and limescale inside the
appliance. To prevent this, we
recommend to run long duration
programmes at least 2 times per month.
With some problems, the display shows
an alarm code.
Possible solution
18