Network - Instar In-5905 Hd Handbuch

l

5.2 NETWORK

5.2.1 NETWORK/IP CONFIGURATION
5.2.2 NETWORK/WiFi
the Test function to verify your settings. Please disconnect the LAN cable and wait about
30-60 seconds for the camera to connect to your WiFi network. The camera will receive
a new address from your router if you didn't assign a static IP address to your camera
previously (Chapter. 5.2.1), therefore you should use the INSTAR Camera Tool again to
rediscover your camera (Chapter 4).
Attention:
Your WiFi modules MAC address is not identical with the LAN MAC address of your
camera! If you are using a MAC filtering rule for your WiFi network, please deactivate
the filter and add your camera to the list of trusted devices before reactivating it.
Additional Remark:
Your camera supports a range of encryption standards - we recommend for the safety
and reliability of your connection - that you set your WiFi network to WPA2 (PSK) with
AES (or CCMP). With older routers choose WPA (PSK) / AES. Avoid using a mixed
mode like WPA&WPA2 - TKIP! If your WiFi stays unstable please choose a fixed WiFi
channel for your router - we recommend the channels 1 - 6.
You can set whether the camera will be assigned an IP
address by your router (DHCP) or you want to manually
set a fixed address. Please check page 9 &10 on how to
set a fixed IP address. In general, we recommend that you
deactivate the automatic service and set a manual IP to
avoid further trouble with the remote access to your cam-
era. For the RTSP Port please refer to 10. RTSP Streaming
for details on the use of the camera´s RTSP videostream.
If you cannot use the WPS service (Wireless Portected Set-
up) to integrate the camera into you local WiFi network -
see included flyer Plug & Play for further information for the
WPS function - click search
to start the WLAN scanner.
Just choose your own network and click "Join". Now you
simply have to add the WiFi password (WLAN Key) and
click submit to save the settings. Afterwards you can use
13-
EN