Instar IN-5905 HD Handbuch Seite 46

Connect the camera to your Network
Please take out the package content from the box: the camera, a CAT5e LAN cable, a 5
dBi SMA WiFi antenna, mounting bracket and the software CD.
Connect the WiFi antenna to the SMA connector on the back
of camera and align it vertically to your router. (see #1, page 5).
Please place the camera close to your Wifi router for the rest of
the installation process. Please be aware that the camera has to be
installed via LAN cable first before it can be used in your wire-
less network - for an alternative please refer to the included flyer
Plug&Play for a WPS integration.
Plug the supplied ethernet cabel to the RJ45 LAN port
on the camera cable (see #6, page 5) and use it to connect
the camera to a free LAN port of your LAN router. For
a direct connection to your Windows PC or Mac please
refer to our FAQ section on faq.instar.de. But we recom-
mend to connect the camera to your network router for
the initial installation.
Connect the power adapter to the camera cable (see #8, page
5) and plug it into a suitable power outlet. Both network indi-
cator LEDs on the network port will light up showing that the
camera is connected to your network.
The orange LED of the LAN port signals a hardware link
to your router and therefore should be on continuously.
The green LED should be flashing irregularly indicating
network traffic. The green status LED on the power supply
has to be on continuously indicating a steady power sup-
ply. Please plug the power supply directly into a wall socket.
Using it on a multi-power strip or an extension cord is not
recommended.
6-
EN