GRAUPNER OPTO-AUTO-PILOT Bedienungsanleitung Seite 13

OAP sensor
Front face of fuselage
Axis
Front
Sensor installation mode: "X"
View of underside of fuselage
Axis
Front face of fuselage
OAP sensor
Important note: the slide-switch must coincide with the installation
mode!
6. Pre-flight checking
6.1 Check first that the aileron and elevator functions work
correctly with the OAP system switched off.
Adjust the OAP function to suit your radio control system, and
set its sensitivity to minimum by turning the adjuster anti-
clockwise.
6.2 Connect the lead marked AUX to a switched channel on the
receiver. Move the ON / OFF switch on the transmitter to the
OFF position.
6.3 If the AUX channel is connected to a proportional receiver
output, set the sensitivity to zero at the transmitter.
7. Checking that the OAP works correctly
7.1 Locate the sensitivity adjuster on the Auto-Control-Board
(ACB) and set it to maximum; this helps when checking the
automatic stabilisation function.
7.2 All the model aircraft's control surfaces should now be at
neutral (centre). If not, turn the model round or place it on a
more suitable flat surface.
GRAUPNER GmbH & Co. KG D-73230 KIRCHHEIM/TECK GERMANY
Änderungen vorbehalten! Keine Haftung für Druckfehler! Id.-Nr. 0059780
Axis
Sensor
Axis
Axis Axis
Front Sensor
13
08/2008