Cleaning; Replacing The Grinding Disc; Storage; Disposal - FLORABEST FSG 85 D1 Originalbetriebsanleitung

Cleaning

Do not use cleaners or solvents. Chemicals
may damage plastic parts on this product.
Never clean the product under running
water.
Clean the product after every use.
Clean the vents
21
product with a soft brush or a cloth.
Clean the chain guide
If very dirty, loosen the chain tensioner
locking screw
10
tensioner with rotary table
access. We recommend removing the side
panels for cleaning.
Replacing the grinding
disc (see Fig. E)
Information about replacing the
grinding disc:
Never operate the product without the
visual cover .
20
Verify the speed specified on the grinding
disc is equal to or greater than the
18a
rated idle speed of the product. Verify the
dimensions of the grinding disc fit the prod-
uct. If the max. rotational speed of the disc
is too low for the product, it could break!
Always use grinding discs in good condi-
tion (ringing test).
Do not widen the uptake bore in the grind-
ing disc if it is too small.
Do not use separate reducing bushings or
adapters to fit grinding discs if the bore is
too large.
Do not use saw blades.
Always completely reassemble the product
after replacing the grinding disc.
Switch off the product and
unplug from the mains. Allow the
product to cool down.
Loosen the 3 fastening screws
remove the grinding disc cover
Unscrew the grinding disc nuts
and the surface of the
with a brush.
7
and remove the chain
for better
12
and
5
.
3
by hand.
18b
Remove the grinding disc
holder.
Place the new grinding disc on the uptake
and tighten the grinding disc nuts by hand.
Reinstall the grinding disc cover
Note: Do not over-tighten the grinding disc
nuts to prevent the grinding disc and nut
from breaking
Perform a test run of at least 30 seconds
without load before using this product for
the first time and after changing the grind-
ing disc. Switch off the product immediately
if the grinding disc is out of round, consider-
able vibration occurs or you notice abnor-
mal noise.

Storage

Store the product in a dry location pro-
tected from dust, out of the reach of children.
Note: Grinding discs must be stored dry
and upright, never stack.

Disposal

The packaging is made entirely of
recyclable materials, which you may
dispose of at local recycling facilities.
The Green Dot is not valid for
Germany.
Observe the marking of the
packaging materials for waste sepa-
b
a
ration, which are marked with abbre-
viations (a) and numbers (b) with
following meaning: 1–7: plas-
tics / 20–22: paper and fibre-
board / 80–98: composite materials.
The product and packaging materi-
als are recyclable, dispose of it sepa-
rately for better waste treatment. The
Triman logo is valid in France only.
from the
18a
.
3
GB 13