Installation; Mounting On A Stand; Overhead Rigging - EuroLite LED KLS--170 Bedienungsanleitung

Mounting on a stand

For mobile use place the light set on a lighting stand via the stand sleeve and fasten the fixation screw. Suitable
stands can be found in chapter Accessories.
Notes
• Please make sure the load is installed in a balanced way and the carrying capacity of the stand is not exceeded.
• Install the stand on a plane area (inclination angle max. 5°) and out of the reach of people.
• Depending upon the individual installation spot, all necessary measures against movement and for securing the
standing safety have to be created (also in case of fire).

Overhead rigging

Truss
mounting clamp
Fixation screws
This product is designed for overhead rigging to a wall or ceiling with the mounting brackets. It can also be
fastened to a truss using appropriate clamps. To align the control unit, release the fixation screws at the mounting
brackets, adjust the desired inclination angle and retighten the fixation screws. Align the LED spots in the same
way.
Risk of injury caused by falling objects
Devices in overhead installations may cause severe injuries when crashing down. Make sure that the
device is installed securely and cannot fall down. Make sure that the installation complies with the
standards and rules that apply in your country, in particular EN 60335-1:1996.

INSTALLATION

Safety bond
WARNING!
23 • EN
Truss
mounting clamp