Handover Certificate; Log Book; Setting Up For Operation; Initial Instructions - Kessel NS 25 Bedienungsanleitung

The chapter "Safety instructions" must be heeded.
Before the separator is put into operation, please make sure

6.1 Setting up for operation

that:
 the separator is clean and the interior is free from any ob-
jects which may have been placed inside during shipping
or installation.
 the separator is completely filled with clean cold water.
Completely filling the separator is complete when water
begins to drain from the outlet.

6.2 Initial Instructions

Placing the separator into full operation is normally handled
by a licensed tradesman although upon request can be hand-
led by a KESSEL representative.
The following personnel should be on hand when the initial
instructions for placing the separator into operation are given:
 Building facilities manager
 Building maintenance workers
 Contracted plumber / tradesman
 Contracted disposal company
The chapter 'Safety instructions' must be heeded.
Important - a proper and timely disposal of the separator in-
sures that the system operations properly and as designed.
Grease separator disposal work should be handled by a li-
censed disposal company. Disposal of the separator should
take place during off hours as a separator with open covers
will release unpleasant odours.
Disposal should take place before the storage capacity of the
sludge collection area (which is half of the sludge storage vo-
lume) and the grease collection area are exceeded. Under
normal circumstances a monthly complete disposal as well
as internal cleaning of the separator is sufficient. After dis-
posal and cleaning, the separator should be completely fil-
led (to outlet level) with water. In the case that large volu-
mes of sludge or grease are collected quickly inside the se-
parator, the disposal intervals should be shortened respec-
tively. The following measures should be taken when dispo-
sing a grease separator:
Complete disposal and internal rinsing /
cleaning of the separator
Automated separators with disposal and cleaning systems
should be checked for proper system operation
Any remaining solids, debris or deposits should be removed
Cleaning of the odour tight cast iron manhole covers as well

6. Operation

What to do:
Check to make sure the separator is completely wa-

tertight. Check to make sure that during transport and
installation that no damage to the separator was
caused. Check to make sure all connections to the
separator (inlet, outlet, refill, rinse pipes etc.) are in
perfect working order.
Representative should discuss all necessary infor-

mation regarding the disposal.
Representative should take the customer step by step

through all stages of a separator disposal.
After the separator has been emptied (disposed) all

necessary paperwork and documentation should be
handed over to the customer.
The separator should be returned to service by filling

the separator with fresh, cold water.
6.4 Hand-over of installation and user's manual.
6.5 Completion of the commissioning report.
After commissioning has been completed the separator
should be placed into normal operation mode.
6.3 Commissioning report (see attachment)
7. Disposal
as inspection of the cover's sealing gasket
If a sampling chamber is present it should also be sprayed
down and cleaned
After disposal and cleaning is complete the entire separator
should be completely refilled with water.
Disposal
Loosen the locking bolts on the separator's manhole cover(s)
using the included hand tool
➤ Remove the manhole cover(s)
➤ Insert vacuum disposal hose from the disposal vehicle
to the base of the separator and suction out entire con-
tents
➤ Spray down interior of separator and remove any solids
or deposits
➤ Completely fill separator with water
➤ Replace manhole cover(s) - check condition of manho-
le cover and gasket
➤ Tighten bolts on manhole cover(s)
➤ Enter disposal date and information in log book.
28