Initial Operation - Bosch PTS 10 Originalbetriebsanleitung

OBJ_BUCH-783-003.book Page 42 Thursday, November 19, 2009 4:24 PM
42 | English
– Fastening kit for "table extension" 41
(2 guide rods, 2 securing screws, 2 clips,
2 short fastening knobs)
– Parallel fences 8 and 10
– Auxiliary parallel fence (aluminium) 18
with profile rail 47
– Auxiliary parallel fence (plastic) 49
– Angle stop 16
– Fastening kit for "auxiliary parallel guide" 45
(4 short screws, 2 long fastening knobs 48,
2 square nuts and washers)
– Blade guard 6
– Fastening kit for "blade guard" 40
(screw, nut, washer)
– Riving knife 4 with pre-mounted hexagon
bolt 36
– Vacuum hose 34
– Hold-down stick 22
– Ring spanner 17
for machine versions with base unit:
– Base unit 69
(12 Profiles, 4 end caps)
– Fastening kit for base unit 68
(24 screws with nuts for assembly, 4 screws
with nuts for fastening of the machine, 4
washers)
Note: Check the power tool for possible dam-
age.
Before further use of the machine, check that all
protective devices are fully functional. Any light-
ly damaged parts must be carefully checked to
ensure flawless operation of the tool. All parts
must be properly mounted and all conditions
fulfilled that ensure faultless operation.
Damaged protective devices and parts must be
immediately replaced by an authorised service
centre.
1 609 929 T49 | (19.11.09)

Initial Operation

– Carefully remove all parts included in the de-
livery from their packaging.
– Remove all packaging material from the ma-
chine and the accessories provided.
– Take special care to ensure that the packag-
ing material under the motor block is re-
moved.
Additionally required tools (not in delivery
scope):
– Phillips screwdriver
– Angle gauge
– Box-end or open-end spanner (size 13 mm)
for assembly of the base unit
Assembly Sequence
For easier working, observe the assembly se-
quence of the supplied product features.
1. Assembly from Below
– Vacuum hose 34
– Bottom plate 35 with pre-mounted Phillips
screws
2. Assembly from Above
– Riving knife 4
– Blade guard 6
– Table extension 2
– Parallel fence 8, auxiliary parallel fences (18
or 49) and angle stop 16
Assembly from Below
– Place down the power tool upside down on
its saw table 11.
Mounting the Vacuum Hose (see figure a)
– Connect the sawdust ejector on the saw
blade casing and the sawdust ejector 32 on
the machine housing with the vacuum hose
34.
Mounting the Bottom Plate(see figure b)
– Insert the bottom plate 35 into the intended
recesses so that the Phillips screws can be
screwed into the holes of the housing.
– Fasten the bottom plate by screwing in and
tightening the Phillips screws.
Bosch Power Tools