Bosch PTS 10 Originalbetriebsanleitung Seite 41

OBJ_BUCH-783-003.book Page 41 Thursday, November 19, 2009 4:24 PM
Technical Data
Table saw
Article number
Rated power input
Rated voltage
Frequency
No-load speed min
Reduced starting
current
Weight according to
EPTA-Procedure
01/2003
Protection class
Maximum workpiece dimensions, see page 48.
The values given are valid for nominal voltages [U] of
230/240 V. For lower voltage and models for specific
countries, these values can vary.
Please observe the article number on the type plate of
your machine. The trade names of the individual ma-
chines may vary.
Dimension of suitable saw blades
Saw blade diameter
Blade thickness
Mounting hole diameter
Noise Information
Measured sound values determined according
to EN 61029.
Typically the A-weighted noise levels of the
product are: Sound pressure level 97 dB(A);
Sound power level 110 dB(A). Uncertainty
K =3 dB.
Wear hearing protection!
Bosch Power Tools
Declaration of Conformity
We declare under our sole responsibility that
PTS 10
the product described under "Technical Data" is
3 603 L03 2.. in conformity with the following standards or
standardization documents: EN 61029 accord-
W 1400
ing to the provisions of the directives
V 230
2004/108/EC, 98/37/EC (until 28 Dec 2009),
2006/42/EC (from 29 Dec 2009).
Hz 50
EC Type Certification No. 3400636.01CE by no-
-1
5000
tified testing agency No. 2140.
Technical file at:
Robert Bosch GmbH, Dept. PT/ESC,
kg 23.5
D-70745 Leinfelden-Echterdingen
Dr. Egbert Schneider
Senior Vice President
/II
Engineering
Robert Bosch GmbH, Power Tools Division
D-70745 Leinfelden-Echterdingen
Leinfelden, 04.07.2008
Assembly
mm 254
mm 1.8
mm 30
Delivery Scope
Before starting the operation of the machine for
the first time, check if all parts listed below have
been supplied:
– Table saw
– Bottom plate 35 with pre-mounted Phillips
– Table extension 2
Dr. Eckerhard Strötgen
Head of Product
Certification
Avoid unintentional starting of the ma-
chine. During assembly and for all work on
the machine, the power plug must not be
connected to the mains supply.
Please also observe the repre-
sentation of the delivery scope
at the beginning of the operat-
ing instructions.
(Preassembled: Table width enlargement 9,
saw blade 38, insert plate 3)
screws
1 609 929 T49 | (19.11.09)
English | 41