Beep Function (Beep) - Metz MECABLITZ 58 AF-2 Sony Bedienungsanleitung

• Press the
selection.
1/1
• Choose the setting desired using the
Set
arrows. The setting takes effect immediately.
• Press
mal reading. If the button
display will change back to the normal view after
about 5 seconds.

7.2 Beep function (Beep)

The beep function allows the user to receive an acoustic signal for certain func-
tions of the flash unit. This allows the photographer to concentrate fully on the
subject and taking the picture, and not have to worry about any optical status
indicators.
The beep function signals when the flash is ready, when the correct flash expo-
sure has been reached, or when an error occurs.
Acoustic signals after the flash unit has been turned on:
• A short (about two seconds) uninterrupted beep signal after turning the flash
on indicates that the flash unit is ready.
Beep signals after taking a photograph:
• A short (about two seconds) uninterrupted beep signal directly after a picture
is taken indicates that the shot was exposed correctly and the flash is ready
again. If no beep signal sounds, then the shot was underexposed.
• A broken (— — —) beep signal directly after a shot indicates that the shot
was correctly exposed. The flash is only ready however after a second (about
two seconds) continuous beep.
116
Set key to confirm the special function
and
repeatedly to return the display to its nor-
is not pressed, the
Beep signals when adjusting automatic mode settings:
• A short beep signal as an alarm in automatic mode indicates that the apertu-
re and ISO settings exceed the permissible light control range. The auto aper-
ture of the mecablitz is then automatically adjusted to the next permissible
value.
Setting procedure:
• Press the Sel button repeatedly until „Select"
appears on the display.
• Use the and buttons to select „BEEP" from
the menu. The selected menu item will be highlighted
against a dark background.
• Press the Set key to confirm the special function
selection.
• Choose the setting desired using the
arrows.
The setting takes effect immediately.
• Press repeatedly to return the display to its nor-
mal reading. If the key not pressed, the display
will switch back to normal automatically after appro-
ximately 5 seconds.
When the beep function is turned on,
the symbol is also displayed on
the LC display.
Select
Beep
Remote
Set
ON
and
Set
TTL F 4.0
MZoom 24
10 m ISO 200