Herunterladen Inhalt Inhalt Diese Seite drucken

Display Illumination; Operating Modes (Mode Menu); Adjusting Procedure For Flash Operating Modes; Ttl- Flash Mode With Measuring Preflash - Metz MECABLITZ 58 AF-1 Leica Bedienungsanleitung

Vorschau ausblenden Andere Handbücher für MECABLITZ 58 AF-1 Leica:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1

4 Display illumination

Every time a button on the flash unit is pressed, the flash display illumination is
activated for 10 seconds. When a flash is fired via the camera or a hand
release, the display lightning

5 Operating modes (mode menu)

TTL
The flash unit supports
with measuring preflash, automatic
M
, and stroboscope modes
Depending on the type of camera, other flash modes may be supported.
These flash operating modes can be selected and activated in the mode
menu following a data transfer with the camera. Depending on the
system, some camera models (depending on the camera's operating
mode) only support the TTL flash mode. Other flash modes (automatic A,
manual M etc.) cannot be selected or activated!

5.1 Adjusting procedure for flash operating modes

• Press the „Mode" button until the word „Mode" appears on the display. You
can choose from the following operating modes:
TTL
TTL flash mode with measuring preflash
TTL
HSS TTL - flash mode with high speed synchronisation HSS
A
Automatic flash mode
M
Manual flash mode
M
HSS Manual flash mode with high speed synchronisation HSS
Stroboscope flash mode
• Set the flash mode of your choice (
using the UP
and DOWN
keys. The flash mode you choose is then high-
lighted. The settings take effect immediately.
• Press the „Return" button
, and the display changes back to the normal
view. If the „Return" button
is not pressed, the display will change back to
84
on the flash unit is switched off.
A
, manual
.
TTL
A
M
, automatic
, manual
the normal view after about 5 seconds.
The flash parameters for ISO, aperture and lens focal length or mirror position
are set automatically, if the camera transfers the necessary data to the flash unit.
The range indicator on the display of the control unit matches the flash parame-
ters transferred from the camera.
If the camera does not transfer one or more flash parameters to the flash
unit, you will have to adjust these settings by hand (see 6).

5.2 TTL- flash mode with measuring preflash

The TTL flash mode with measuring preflash is a further development of the stan-
dard TTL flash mode of analogue cameras. During the shot and before the actual
exposure, one or more almost indiscernible preflashes are executed by the flash.
The light reflected by the preflash is evaluated by the camera. According to the
evaluation, the subsequent flash exposure will be adjusted by the camera to suit
the situation (see the camera's operating manual).
Depending on the camera model, the preflashes precede the main flash
by such a short interval that they practically cannot be distinguished from
the main flash! The preflashes do not contribute to the lighting of the shot.
Setting procedure:
• Press the „Mode" button until „Mode" flashes on the LC display.
TTL
• Set the
flash mode using the UP
you choose is then highlighted. The setting takes effect immediately.
• Press the „Return" button
If the „Return" button
normal view after about 5 seconds.
, etc.)
If the shot was properly lit, the correct exposure indication
about 3 seconds (see 13).
and DOWN
keys. The flash mode
to change the display back to the normal view.
is not pressed, the display will change back to the
will flash „OK" for

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis