Flash Capacitor Forming - Metz MECABLITZ 44 AF-1 digital Bedienungsanleitung

Checking the software version
• Switch off the flash unit by pressing
SL
M
the
are off.
TTL
• Hold down the TTL button
flash unit whilst pressing the
ton.
1/1 1/2 1/8 1/64
On the flash unit, the M button
M SL
LED for partial light output
1/64 will flash.
TTL
The number of flashes shows the software
version e.g. 1/1 LED flashes once and the
1/64 LED 3 times to install software versi-
on 1.3.
Further information can be found on
the Metz website: www.metz.de
k

13.2 Flash capacitor forming

The flash capacitor built into the flash unit
undergoes physical change if the unit is
not switched on for a prolonged period.
For this reason it is necessary to switch the
unit on for approximately 10 minutes at
least once every three months. The power
supplied by the power source must be suf-
ficient to cause the flash readiness indica-
tor to light up no more than one minute
102
button until all LED displays
on the
but-
and the
1/1 and
after the flash unit is switched on.
+
+