Set Up Reception Sensitivity; Activate Bass Boost - Silvercrest SWEP 500 A1 - IAN 107035 Bedienungsanleitung

 When the volume reaches level '07', the volume warning icon (33) begins to
flash. You can now only increase the volume further if you confirm the
volume warning by briefly pressing the 'LOCK' button (11). The increased
volume level will remain until the device is next switched off.
 If the volume level during use as a loud speaker was set as higher than level
'07' and earphones were then inserted during use as a radio, the volume will
jump back to level '07'. By pressing the 'VOL+/AL2' button (3) again, the
volume warning icon will begin to flash (33). You can now only increase the
volume further if you confirm the volume warning by briefly pressing the
'LOCK' button (11).
 If the volume level during use as a loud speaker or with earphones was set
as higher than level '07' and the device was then switched off, if it is
switched on again while earplugs are inserted, the volume will jump back to
level '07'. By pressing the 'VOL+/AL2' button (3) again, the volume warning
icon will begin to flash (33). You can now only increase the volume further if
you confirm the volume warning by briefly pressing the 'LOCK' button (11).

Set up reception sensitivity

This function only applies for FM and SW. If you wish to use the device in
normal mode, slide the 'DX/LOCAL' selection switch (23) to the 'DX' position.
If you only wish to receive stations with a high field strength, slide the
'DX/LOCAL' selection switch (23) to the 'LOCAL' position. This is recommended
if, for example, you wish to receive a weak local station that stronger national
stations are blocking out.

Activate bass boost

You have the option of boosting the playback of bass notes.
 During use as a radio, press the 'BASS' button (12). 'BASS' (35) will be
displayed on the screen.
 Press the 'BASS' button (12) again to switch off the bass boost. 'BASS' (35)
will disappear from the screen.
SilverCrest SWED 500 A1
English - 27