Playback In Stereo; Sleep Timer - Silvercrest SWEP 500 A1 - IAN 107035 Bedienungsanleitung

Please note:
The memory locations are not in use in the default setting. When a
memory location not in use is selected, the previously selected
station continues to play.
If a memory location is in use, the stored frequency is maintained
until it is overwritten by saving once again.
If the multi-band radio is not supplied with electricity, the time
settings are lost but any saved stations will be retained.

Playback in stereo

Playback can only be in stereo quality when earphones are attached. When
this is the case, the 'STEREO' icon (37) appears on the screen (5).

SLEEP timer

With the SLEEP timer, you can set a time between 10 and 90 minutes, after
which your multi-band radio (A) will automatically switch off. This can be set in
intervals of ten minutes. Proceed as follows:
 Switch off the device using the 'POWER/SLEEP' button (6).
 Press the 'POWER/SLEEP' button (6) for about one second, until the number
90 (for 90 minutes) appears on the screen (5).
 Now press the 'POWER/SLEEP' button (6) until the desired number of
minutes has been reached (e.g., 40). Each time the 'POWER/SLEEP' button
(6) is pressed, the duration until the radio switches off is reduced by ten
minutes.
 The multi-band radio (A) will now switch on and will switch off automatically
after the number of minutes (e.g., 40) that was selected.
 The 'SLEEP' icon (28) is visible on the screen (5) when the SLEEP timer is
activated.
 While the SLEEP timer is activated you can still change the frequency band,
begin scanning for stations, access saved stations and set the volume.
SilverCrest SWED 500 A1
English - 31