Nap Timer; Stopwatch - Silvercrest SWEP 500 A1 - IAN 107035 Bedienungsanleitung

 Press the 'TIME/MEM' (8) button to set further SDAs.
The activated SDAs will now go off every year. If the current date corresponds
with the SDA alarm, a buzzer tone will go off every hour between 08:00 and
23:00 for about ten minutes. If in use, the radio function of the multi-band radio
will stop. To end this alarm, press any button.

NAP timer

You have the option of setting a timer for a short period (alarm sound only) for
a one-off occurrence. There are five pre-set NAP timers and you can choose
between them using the 'TIME/MEM' button (8). The durations of the five pre-
set timers are all different: 10, 15, 20, 25 and 30 minutes.
 When the radio is switched off, press the 'MODE' button (10) twice. The
NAP timer icon (29) will be displayed on the screen (5), along with the
number of the timer and the pre-set activation time in minutes.
 Press the 'TIME/MEM' button (8) repeatedly in order to activate the pre-set
NAP timer.
 You can use the 'UP' (13) and 'DOWN' (15) buttons to adapt these times to
your requirements, from 1 minute to 39 minutes.
 To start the timer, press the 'TIME/MEM' button (8) for about one second.
 The screen will now display the time counting down. When the timer ends,
an alarm will sound until it is switched off.
The NAP timer alarm can be switched off by pressing any button.

Stopwatch

The stopwatch function can be used as follows:
 When the device is switched off, press the 'MODE' button (10) three times.
The screen will display 0:00 (minutes:seconds) and the bottom right
hand of the screen will also show the hundredths of a second.
 Briefly press the 'TIME/MEM' button (8) to start the stopwatch.
 Briefly press the 'TIME/MEM' button (8) again to stop the stopwatch.
SilverCrest SWED 500 A1
English - 25