Manual Tuning Control; Fine Tuning A Station - Silvercrest SWEP 500 A1 - IAN 107035 Bedienungsanleitung

The shortwave band 'SW; is divided into nine sub-bands, 'SW1' to 'SW9' (see
section entitled 'Specifications'). To select individual sub-bands, now press the
'BAND' button (9) and select the 'SW' band. Now press the 'BAND' button (9)
for about one second, until the 'SW' icon flashes on the screen. You can now
use the 'UP' (13) or 'DOWN' (15) buttons to select the 'SW' sub-bands. When
the 'SW' icon (5) is no longer flashing on the screen (5), you can begin
searching for stations.
 To begin the search in the direction of your choice, press the 'UP' (13) or
'DOWN' (15) button for about one second. The search will stop at the next
station that is found and the frequency will be displayed on the screen (5).

Manual tuning control

Instead of using the station search, you also have the option of configuring
stations manually. This makes it possible to find weaker stations as well. To do
this, proceed as follows:
To increase or decrease the frequency by one step, briefly press either the 'UP'
(13) or 'DOWN' (15) button respectively. The spacing of the steps varies
depending on the frequency band selected. For FM it is 0.1 MHz, 9 kHz for
'AM-EU', 10 kHz for 'AM-US', 5 kHz for 'SW' and 9 kHz for 'LW'.

Fine tuning a station

You have the option of refining the tuning resolution of the tuning controls
according to the following table, in the event that a station cannot be exactly
located.
To configure this, do the following:
 When the radio is switched on, press 'MODE' three times.
 The current frequency is displayed on the screen (5) and the current tuning
resolution is shown in the bottom right-hand corner.
SilverCrest SWED 500 A1
English - 29