Inserting The Batteries - Silvercrest SWEP 500 A1 - IAN 107035 Bedienungsanleitung

SilverCrest SWED 500 A1

Inserting the batteries

Open the battery housing (19) on the back of the device by lifting the battery
housing lid down towards you and removing it. Insert the batteries with the
correct polarity (see the + and - markings), as shown in the following diagram.
The polarity is marked on the batteries and on the battery housing. When
inserting the batteries, ensure that the fabric strip is underneath the batteries.
This makes it easier to remove the batteries when you need to change them.
Now place the two plastic tabs from the battery housing lid into their notches
below the battery housing (19) and lift the battery housing lid up and towards
the radio until it clicks in.
If your screen (5) signals that the battery level is low (32), the batteries have
almost run out of charge. Swap them for new batteries of the same type.
WARNING! Remove the batteries when not using the device
for a prolonged period of time.
18 - English