Remote Control; Error Message - Yamaha HTY-7030 Bedienungsanleitung

Troubleshooting

Remote control

Problem
The remote control does not
work and/or function
properly.
Cannot operate external
components with the remote
control of this unit.
The cursor buttons do not
work during SET MENU
operation.
Cannot use the My Beam
auto-adjust function.
HDMI

Error message

Device Error
HDCP Error
FM tuner
Problem
FM stereo reception is noisy.
There is distortion, and clear
reception cannot be obtained
even with a good FM
antenna.
The desired station cannot
be tuned into with the
automatic tuning method.
Previously preset stations
can no longer be tuned into.
104
En
Cause
Wrong distance or angle.
Direct sunlight or lighting (from an inverter
type of fluorescent lamp, etc.) is striking the
remote control sensor of this unit.
The batteries are weak.
The external component you want to operate
is not selected as the input source.
The remote control code was not correctly
set.
Even if the remote control code is correctly
set, there are some models that do not
respond to the remote control.
The operation mode selector was
unwantedly set to TV/AV.
Wrong distance or angle.
Cause
The number of the connected HDMI
components exceeds the limit.
HDCP authentication failed.
Cause
The characteristics of FM stereo broadcasts
may cause this problem when the
transmitter is too far away or the antenna
input is poor.
There is multi-path interference.
The signal is too weak.
This unit has been disconnected for a long
period.
Remedy
The remote control functions within a
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front
panel.
Reposition this unit.
Replace all batteries.
Press INPUT on the front panel or the input
selector buttons on the remote control to
select the external component you want to
operate.
Set the remote control code correctly or try
another code for the same manufacturer
using the "List of remote control codes" at
the end of this manual.
Use the remote control supplied with the
external component.
Set the operation mode selector to YSP.
The remote control functions within a
maximum range of 6 m (20 ft) and no more
than 45 degrees off-axis from the front
panel.
Remedy
Reduce the number of the connected HDMI
components.
Check that the connected HDMI
components support the HDCP copy
protection standards.
Remedy
Check the antenna connections.
Try using a high-quality directional FM
antenna.
Use the manual tuning method.
Adjust the antenna position to eliminate
multi-path interference.
Use a high-quality directional FM antenna.
Use the manual tuning method.
Preset the stations again.
See
page
30
—
30
45
96
—
—
30
See
page
—
—
See
page
29
—
49
—
—
49
50