Settings; Controlling The Unit With Tv Remote Control (Tv Remote Control Learning Function) - Yamaha YSP-1400 Bedienungsanleitung

Settings

Controlling the unit with TV remote control (TV
remote control learning function)
You can use the TV remote control to turn on/off the unit or adjust its volume by having
the unit learn the TV remote control signals.
NOTE
• This function is available only when your TV remote control uses infrared signals.
• Depending on the installation conditions or settings of the unit, both the unit and TV will receive the TV
remote control signals and operate simultaneously.
1
Turn off the TV and unit.
2
Hold down the LEARN key on the supplied remote control for more
than 3 seconds to set the unit to the learning mode.
When the unit is in the learning mode, the indicators on the front panel flash as
shown below.
NOTE
• Steps 3 to 6 require only the TV remote control and the keys on the front panel of the unit. The
remote control of the unit is not necessary.
3
Make the unit learn the mute operation.
3-1 Press INPUT on the front panel of the unit.
3-2 While pointing your TV remote control at the remote control sensor, hold
down the mute key for more than 1 second twice or three times.
Approx. 30 cm (1 ft)
TV remote control
Hold down Release
(more than 1 second) (more than 1 second) (more than 1 second)
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 3-1.
4
Make the unit learn the volume (–) operation.
4-1 Press VOLUME (–) on the front panel of the unit.
4-2 While pointing your TV remote control at the remote control sensor, hold
down the volume (–) key for more than 1 second twice or three times.
Result Bleep/buzzer
Successfully
Once
learned
Learning has
failed
Twice
* Repeat from
Step 4-1.
Hold down Release
(more than 1 second)
Indicators
Lights up
Flash
Indicators
Lights up
Flash
Continued
➜
13