7.7 Cleaning The Front Wheel; 7.8 Cleaning The Side Brushes - Philips HomeRun FC9910 Benutzerhandbuch

7.7 Cleaning the front wheel

Push the latch hooks on either side of the
1
front wheel retainer to unlock them (1) and
lift the front wheel retainer off the robot (2).
Remove dust and dirt from the brush strip
2
on the retainer with the comb end of the
cleaning tool or with your fingers.
Remove the front wheel from the robot (1)
3
and remove dust and dirt from the wheel
with the brush end of the cleaning tool (2).
Note:
D
You can find the cleaning tool on the inside of
the dust container compartment cover (see
section 'Emptying the dust container' in this
chapter).
26
1
1
Put the front wheel back into the robot (1).
4
Then place the front wheel retainer over the
front wheel and press it home until the latch
hooks lock into place with a click (2).
2

7.8 Cleaning the side brushes

To remove a side brush from the robot, grab
1
two arms of the side brush and pull the side
brush upwards with two hands.
2
Remove dust and dirt from the side brush
2
with the comb end of the cleaning tool or
with your fingers.
To remount the side brush, align the hole in
3
the centre of the side brush with the half-
round mounting pin on the bottom of the
robot and push the side brush into position
Repeat steps 1 to 3 to clean the other side
4
brush.
1 2