Before First Use; Inserting The Rechargeable Battery; Mounting The Side Brushes; Removing The Transparent Plastic Foils - Philips HomeRun FC9910 Benutzerhandbuch

4 Before first use
4.1 Inserting the rechargeable
battery
The rechargeable battery needs to be
inserted before use.
Place the robot upside down on a soft, flat
1
surface.
Align the latches on the sides of the
2
rechargeable battery with the recesses in the
side of the battery compartment and insert the
rechargeable battery. Press the rechargeable
battery home until it locks into place ('click').
Note:
D
Although the rechargeable battery is partially
charged at the factory, you may have to
charge it before you can use the robot.
4.2 Mounting the side brushes
Unpack the side brushes. There is one brush
1
for the left side of the robot (marked L) and
one brush for the right side of the robot
(marked R).
Align the holes in the centre of the side
2
brush with the half-round mounting pin on
the bottom of the robot and push the side
brush into position.
12
CLICK
4.3 Removing the transparent
plastic foils
Turn over the robot and remove the
1
transparent plastic foil from the display (1).
Then remove the transparent plastic foil from
the infrared signal generator of the base
station (2).
4.4 Inserting batteries into the
remote control
Two non-rechargeable batteries (AAA 1.5V
alkaline) for the remote control are supplied
with your homeRun. insert the batteries into
the battery compartment before you use the
robot. Replace the batteries with batteries of the
same type when they are empty.
Remove the battery compartment lid (1)
1
and insert the batteries into the battery
compartment lid (2).
Reattach the battery compartment lid.
2
Note:
D
Make sure the + and - poles of the batteries point
in the right direction.
1
1
2
2