Error Codes - Philips HomeRun FC9910 Benutzerhandbuch

14 Error codes

Error codes
E0
E1
E2
E3
E4
E5
E6
E7
E8
32
Cause
Rechargeable battery is
empty
Wheel lifted
Floor detection error
Dust container error
Wheel motor overload
Brush motor overload
Robot motor overload
inner system error
Front wheel slipping or not
moving
solution
Charge the robot.
The robot is stuck on a threshold or another
height difference. Move it to a flat area.
Move the robot to a flat area.
The dust container is not properly inserted. insert
the dust container properly (see steps 6 to 8 in
'Emptying the dust container' in chapter 'Cleaning
and maintenance').
Check if there is any dirt (hair, fluff etc.) attached
to the wheels. Remove the dirt (see chapter
'Cleaning and maintenance').
Check if there is any dirt (hair, fluff etc.) attached
to the roller brush or side brushes. Remove the
dirt (see chapter 'Cleaning and maintenance').
Clean the filters and empty the dust container
(see chapter 'Cleaning and maintenance').
Set the on/off switch to OFF and then set it to
ON again.
Check if the robot can move forward freely
and if there are any objects that block its
movements. Check if the front wheel can turn
freely by turning the robot upside down and
moving the wheel with your hand. if the wheel
jams, the wheel may be dirty. Clean the front
wheel (see chapter 'Cleaning and maintenance').