Overview Of The Appliance - Kärcher Puzzi 8-1 C Originalbetriebsanleitung

Overview of the appliance

Illustrations on Page 2
1 Cover
2 Fresh water tank
3 Carrying handle
4 Holder for floor nozzle (not intended
for transport)
5 Spray/suction hose
6 Fresh water hose
7 Suction hose
8 Manual nozzle for upholstery cleaning
9 Bender
10 Handle
11 Dirt water reservoir, detachable
12 Suction pipe
13 Floor nozzle
14 Connection, spray hose
15 Fluff filter
16 Suction hose connection
17 Fresh water strainer
18 Hook for spray/suction hose
19 Switch for vacuuming
20 Switch for spraying
21 Transport bracket for manual nozzle
22 Mains cable with mains plug
Start up
see Figure 1
Insert the holder for the floor nozzle into the
appliance and lock into place.
see Figure 2
Insert the suction hose into the suction
hose connection on the appliance.
Insert the coupling of the fresh water
hose into the fresh water connection of
the appliance and lock into place.
Connect the coupling of the fresh water
hose to the bender and lock into place.
Selecting the nozzle
Upholstery, wall rugs,
automobile interior
cleaning
Carpeting
Stairs
* not included in the delivery
Manual nozzle
Floor nozzle
Carpet nozzle
*
EN
Operation
see Figure 3
Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Note
Warm water (max. 50°C) will increase the
cleaning effect.
For considerate treatment of the environ-
ment use detergent economically.
Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
Insert dirt water reservoir into the appli-
ance and attach lid.
Plug in the main plug.
see Figure 4
Press the suction switch to turn on the
suction turbine.
Press the spray switch to turn on the de-
tergent pump.
Warning
Risk of damage. Check the object to be
cleaned prior to using the appliance in an
inconspicuous place for colour fastness
and water resistance.
see Figure 5
Use the lever on the bender to spray on
detergent solution.
Run across the surface to be cleaned in
overlapping paths. Pull the nozzle back-
wards (do not push).
see Figure 6
During nozzle changes, the manual
nozzle can be inserted into the holder
for the manual nozzle.
Empty the dirt water reservoir.
If the dirt water reservoir is full, switch
off the suction and spray switches.
Remove the lid.
see Figure 8
Remove the dirt water reservoir from
the appliance and empty it.
2
-
11