Overview Of The Appliance; Selecting The Nozzle - Kärcher Puzzi 100 Originalbetriebsanleitung

Overview of the appliance

Illustrations on Page 2
1 Casing
2 Carrying handle
3 Fresh water tank with sieve
4 Dirt water reservoir, removable
5 Cover
6 Switch for spraying
7 Switch for vacuuming
8 Spray/suction hose
9 Power cord
10 Suction pipe
11 Manual nozzle for upholstery cleaning
(option)
12 Container for defoamer (Puzzi 200)
13 Storage container for detergent tabs
(Puzzi 200)
14 Additional socket for professional PW
10
15 Floor nozzle for carpet cleaning
16 Handle
17 Bender
Start up
Place suction pipe over floor nozzle and
tighten union joint on the floor nozzle
fingertight (left thread).
Caution
While connecting make sure that the spray
tubes meet in the suction pipe and the floor
nozzle.
If needed, slide handle onto suction
pipe and attach in the desired position
using the enclosed hexagon socket
wrench.
Place the elbow over the suction pipe
and tighten the union joint on the elbow
fingertight.
Caution
While connecting make sure that the spray
tubes meet in the suction pipe and the el-
bow.
Illustrations on Page 2
Insert the suction hose into the suction
hose connection on the appliance.
Insert the coupling of the fresh water
hose into the fresh water connection of
the appliance and lock into place.
see Figure 1
Connect the suction hose to bender of
the manual nozzle.
Connect the coupling of the fresh water
hose to the bender and lock into place.
see Figure 2
The manual nozzle for upholstery cleaning
(not included) is attached directly to the
suction hose without the use of an elbow.

Selecting the nozzle

Carpeting
Upholstery, wall rugs,
automobile interior
cleaning
Stairs
* not included in the delivery
Illustrations on Page 2
Mix fresh water and detergent in a clean
container (use the concentration rec-
ommended for the detergent).
see Figure 3
Warning
Health risk, risk of damage. Observe all in-
dications on the detergent used.
Note
Warm water (max. 50°C) will increase the
cleaning effect.
For considerate treatment of the environ-
ment use detergent economically.
Fill detergent solution into the fresh wa-
ter reservoir. The fill level must not ex-
ceed the "MAX" mark.
see Figure 4
Insert dirt water reservoir into the appli-
ance and attach lid.
Plug in the main plug.
2
-
EN
Floor nozzle
(230 mm)
Manual nozzle
(110 mm) *
Carpet nozzle *
Operations
11