Checking The Oil Automatic System; Changing The Saw Bar; Fitting The Saw Chain - FLORABEST FKS 2200 B1 Originalbetriebsanleitung

1. Place the electric chainsaw onto
E
a solid, flat surface. It must not
contact any objects.
2. Connect the device to the mains
voltage.
3. Release the chain brake by
shifting the brake arm (3) over
against the front grip (8).
4. Hold the electric chainsaw firmly
with both hands, with the right
hand on the rear handle
and the left hand on the front
handle (8). Thumb and finger
must close securely over the han-
dles.
5. Turn on the electric chainsaw.
6. Activate the chain braking lever
(3), with running motor, with
the left hand. Chain should stop
abruptly.
7. Once the chain brake is work-
ing properly, release the on/off
switch (10) and the chain brake.
. If.the.chain.brake.does.not.
function.correctly,.you.must.
not.use.the.electric.chainsaw..
A.slack.saw.chain.leads.to.
danger.of.injury...
Return.the.electric.chainsaw.
to.our.Service-Center.for.re-
pair..
Checking the oil automatic
system
Check the oil level and the automatic oil
system before commencement of work.
• Switch on the chainsaw and hold it
above a bright background. The saw
must not touch the ground.
If an oil trace can be seen, the chainsaw is
working trouble-free.
J 4. Clean the oil passages of the
( 1)
A

Changing the saw bar

1. Switch the saw off and unplug it
F
2. Lay the saw on a flat surface.
3. Turn the fastening bolt (14) anti-
4. Remove the saw bar (4) and saw
5. To fit the new bar, place the bar

Fitting the saw chain

1. Switch the saw off and unplug it
G
2. Spread the chain (5) out into a
3. Slide the saw chain (5) into the
If no oil trace can be seen clean the
oil passages or turn the chainsaw
to our Service-Center for repair.
chain bar (25), in order to guar-
antee a trouble-free, automatic
oiling of the saw chain during
operation.
from the mains.
clockwise and loose the chain
adjustment ring
the sprocket chain wheel cover-
ing (15).
chain ( 5). To remove the guide
A
bar (4), raise it to an angle of ap-
prox. 45 degrees. This will make
it easier to take the saw chain (5)
off the sprocket
(4) onto the bar bolt (21) with
the tensioning plate pointing out-
wards (22).
from the mains.
loop with the cutting edges run-
ning clockwise .
bar guide groove. To mount the
guide bar (4), raise it to an angle
GB
( 13) to remove
A
( 23).
G
59