Atag CM4511AC Bedienungsanleitung Seite 77

TROUBLESHOOTING
FAULT
Coffee does not come out
of the spouts on the coffee
dispenser but out of the
service door at the side.
Milk is frothed up too much
or too little.
CAUSE
The holes on the coffee
dispenser are blocked with
dried on coffee.
The swing drawer on the
inside of the service hatch is
blocked and will not move.
Wrong setting of the slider on
the lid of the milk container.
If the milk is not frothy enough,
the milk container may not be
correctly in place.
SOLUTION
Remove the dried on coffee
with a needle (see "Cleaning
the coffee machine").
Carefully clean the swing
drawer, particulary in the area
around the hinges so that
these continue to move.
You can set the amount of
froth on the milk to any level
using the slider on the lid:
'CAPPUCCINO' (very frothy
milk) or 'CAFFE LATTE' (not
so frothy milk).
Put the milk container
correctly in place.
EN 37