Operation - Atag CM4511AC Bedienungsanleitung

USE

Operation

2 3 4 6
8. Open the lid and fill the container with coffee beans, then close the
lid and push the appliance in. The coffee maker is now ready for
normal use.
Only fill the water tank with cold water. Never use other liquids
such as mineral water or milk.
To prevent malfunctions, never fill with ground coffee, frozen or
caramelised coffee beans or anything else that could damage the
appliance.
• When using the appliance for the first time, you need to make 4-5
cups of coffee and 4-5 cappuccinos before the appliance gives
satisfactory results.
• Each time you turn the coffee maker on by the main switch (A), it
performs a "SELF-DIAGNOSIS" cycle and then goes off. To turn it
on again, press the On/stand by button (Aa).
Preparing coffee (using coffeebeans)
• The appliance is preset to make coffee with a normal taste.
You can also choose coffee with an extra mild, mild, normal, strong
or extra-strong taste. There is also a pre-ground coffee option.
• To choose the required taste, press more times the touch key
'Coffee strength' (2). The required coffee taste is displayed.
1. Place 1 cup under the spouts to make 1 coffee or 2 cups for
2 coffees.
2. Lower the spouts as near as possible to the cup for a creamier
coffee.
3. Press the 'type of coffee' touch key (3) to select the type of coffee:
• ESPRESSO
• MEDIUM CUP
• LARGE CUP
4. Press the 'one cup of coffee deliver' touch key (4) if you want to
make one coffee and the 'two cup of coffee deliver' touch key (6)
if you want to make two coffees.
▷ The appliance now grinds the beans and starts delivering the
coffee into the cup.
EN 11