Atag CM4511AC Bedienungsanleitung Seite 52

USE
2 3 4
EN 12
▷ Once the set amount of coffee has been delivered, the machine
stops delivery automatically and expels the exhausted waste
coffee into the waste coffee container. After a few seconds, the
appliance is ready for use again.
Tips
• To turn the appliance off, press the 'On-off' button (Aa / see page 5).
Before going off, the appliance performs an automatic rinse cycle.
Take care to avoid scalds.
• If the coffee only comes out in drips or not at all, the knob for setting
the grind level must be turned by one position clockwise (see
"Setting the grind level"). Turn one click at a time until the coffee is
delivered satisfactorily.
• If the coffee comes out too fast and the cream does not meet your
taste, turn the knob by one position anti-clockwise). Make sure that
you do not turn the knob for setting the grind level too far, as coffee
may come out in drips when dispensing 2 cups.
• You can stop the coffee from dispensing by pressing the 'One cup
of coffee deliver' touch key (4) or 'Two cup of coffee deliver' touch
key (6) again.
• After the coffee has finished dispensing (the progress bar reaches
100%), you can change the amount of coffee the next time by
6
pressing and holding the 'One cup of coffee' touch key until the
desired amount of coffee is reached (see 'Changing the quantity of
coffee').
• When the display shows the message "FILL TANK!", you must fill the
tank, otherwise the appliance cannot make any coffee. It is normal
that there is some water left in the water tank when the message is
displayed.
Tips to make hotter coffee
• After 3 minutes since you last made coffee, you can preheat the
brewing unit by using the menu setting "RINSING (see Rinsing page 20).
Run off the water into the underlying drip tray or alternatively use
this water to fill (and then empty) the cup to be used for the coffee.
• Do not use cups that are too thick, as they will absorb too much
heat.