Atag CM4511AC Bedienungsanleitung Seite 67

SETTINGS
▷ After about 30 minutes, the message "RINSING FILL TANK" is
displayed. The appliance is now ready for a rinsing process with
clean water.
7. Empty the container used to collect the descaler solution.
8. Take out the water tank, empty the watertank and fill it with clean
water.
9. Put the water tank back in place and put the container back under
the coffe spouts and the hot water spout.
The display shows: "RINSING PRESS OK".
10. Press the touch key 'OK' (5).
▷ Hot water flows out of the coffee spouts and the message
"RINSING PLEASE WAIT" is displayed.
▷ Once the rinsing is finished, the message "RINSING FILL TANK"
is displayed.
11. Empty the container used to collect the water used for rinsing.
12. Take out the water tank, empty the watertank and fill it with clean
water.
13. Put the water tank back in place and put the container back under
the coffe spouts and the hot water spout.
The display shows: "RINSING PRESS OK".
14. Press the touch key 'OK' (5).
▷ Hot water flows out of the hot water spout.
▷ Once the rinsing is finished, the display shows "RINSING
COMPLETE PRESS OK".
15. Press the touch key 'OK' (5).
▷ The appliance goes off automatically.
If the descaling cycle is interrupted before completion, the appliance
continues to display the descale message and the program must be
started again from the beginning.
Failure to descale the appliance invalidates the guarantee.
EN 27