Atag CM4511AC Bedienungsanleitung Seite 59

USE
N3
N
After a few seconds, the appliance starts delivering coffee into
the cup and the message "COFFEE FOR CAPPUCC. PROGRAM
QUANTITY" or "COFFEE FOR MACCHIATO PROGRAM QUANTITY"
is displayed.
5. Once the required quantity of coffee has been delivered into the cup,
press the 'Cappuccino deliver' touch key (12) or 'Latte Macchiato'
(13) touch key again. Coffee delivery stops.
The machine is now reprogrammed with the new milk and coffee
quantities.
Cleaning the spouts
Clean the spouts on the milk container every time after heating milk or
making cappuccino. Otherwise, remains of milk may set hard.
1. Place a container under the milk dispenser pipe and press on the
CLEAN button (N3) on the milk container for at least 5 seconds.
The display shows "CLEANING"!
Warning! Risk of scalding from steam and hot water escaping from
the milk dispenser pipe.
2. Remove the milk container and clean the spouts on the appliance
with a damp cloth.
3. Put the hot water spout back in.
After you finished cleaning, remove the milk container and place it
in the fridge, as the milk should not stay out of the fridge for longer
than 15 minutes. See "Cleaning the spouts and the milk container" for
information on cleaning the milk container.
EN 19