Faults Table - Atag CM4511AC Bedienungsanleitung

TROUBLESHOOTING

Faults table

FAULT
Coffee is not hot.
The coffee does not have
enough crema.
Coffee comes out too slowly.
Coffee comes out too
quickly.
Coffee only comes out of one
of the spouts on the coffee
dispenser.
If the appliance does not work properly, this does not always mean
that it is defective. If the coffee machine does not work and a message
is displayed, refer to the problem solving information (see chapter
'Messages'). If no message is displayed, try to find a solution first by
checking the points mentioned in the table below, or contact the service
department (see the guarantee certificate for details).
CAUSE
The cups were not preheated.
The brewing unit is too cold.
The coffee is too coarsely
ground.
The coffee blend is not
suitable.
The coffee is ground too fine.
The coffee is too coarsely
ground.
The holes on the spouts are
blocked.
SOLUTION
Preheat the cups by rinsing
them out with warm water
(see "Tips to make hotter
coffee").
Warm up the brewing unit
with the rinsing program
before making coffee (see
"Rinsing").
Turn the knob for the grind
level setting one position anti-
clockwise (see "Setting the
grind level").
Use a coffee blend suited
to fully automated coffee
machines.
Turn the knob for the grind
level setting one position
clockwise (see "Setting the
grind level").
Turn the knob for the grind
level setting one position anti-
clockwise (see "Setting the
grind level").
Remove the dry coffee
residues with a needle
(see "Cleaning the coffee
machine").
EN 35