Charging The Handset Batteries - comfortel DECT 650C Bedienungsanleitung

90

Charging the Handset Batteries

A wrong polarity of the AAA batteries can damage the phone.
e
Use only the batteries supplied or the recommended batteries. Never use non rechargeable
batteries. If you use an incorrect battery type there is a risk of explosion or damage to your
handset and it will invalidate your warranty.
Handle the batteries properly. Strictly follow the directions stated in
ing and Handling on page
If the phone was previously used, please check the batteries efficiency and replace them, if neces-
sary.
Charging the Handset Batteries
Before initial operation, you should fully charge the handset's batteries for 15 hours or more.
To charge the batteries, simply place the handset into
base slot as showed: you will hear a confirmation beep
(charging beep).
During the charge the green LED on the base will turn
on. At the same time, the handset will show the bars
inside the battery icon "moving" (shown alternately).
When the charging is complete (battery fully charged),
the bars will be permanently shown.
The first time you charge the batteries, don't remove the handset before 15 hours, otherwise the
batteries duty could be temporarily reduced. After the first charge, you can charge the batteries for
less time according to the energy left.
When possible, charge the batteries when you have fully discharged it (no bars in the battery icon):
this will help them lasting as long as possible. For further references please see the
Checking and Handling on page
The supplied batteries are new, therefore they allow the full duty only after few complete charging/
discharging cycles.
Battery duration will depend on the usage of the handset. In order to increase the duration don't
forget to set the Power Save mode to on (see
If you like, you can disable or change the charging beep. Please see
Charging Beep on page
Handle the batteries properly. Strictly follow the directions stated in
e
ing and Handling on page
85.
85.
125.
85.
LED turns
on during
the change
chapter Setting Display on page
chapter Battery Check-
chapter Battery
127).
chapter Enabling/Disabling
chapter Battery Check-