Sms - Short Message Service; Setting Service Center Number; Setting Terminal Number (Sub Address) - comfortel DECT 650C Bedienungsanleitung

Verfügbare Sprachen

116

SMS - Short Message Service

SMS - S

HORT

ESSAGE

ERVICE

Using the SMS menu, you can create, send, receive, and save your text messages.

IMPORTANT! To enable the SMS feature, you must subscribe to the SMS service supplier and set

the service center numbers in your phone before using it.

You can access to the SMS menu only when the handset is inside the radio coverage of the base.

Setting Service Center Number

To enable the SMS feature you should ask your service supplier the service center numbers and

store it in your phone as follows:

6.SMS Settings

2.Service Ctr2

0193010

You can access the SMS menu only when the handset is inside the radio coverage of the base.

Please note that Service Ctr1 is for messages being sent and Service Ctr2 is for messages being

received.

You can also add a pause by pressing the down navigation key. In this case P will be shown on

the display.

Operation with a PBX: If necessary please add a preceding exchange line access number (e.g. „0")

to the service number.

Setting Terminal Number (Sub Address)

When more than one handset is registered to one base, setting the terminal number (sub address)

on each handset is required. It allows the message sender to specify the handset which will receive

the message by entering the addressee's terminal number.

You can set each terminal number with a number from 0 to 9 with the following steps (0 is the default

value).

Enter Number

Press the SMS key to display the SMS menu

items. Or, press the MENU soft key to display

the main menu items, then select 1.SMS by

pressing the SELECT soft key.

Press repeatedly the navigation keys to

SELECT

choose 6.SMS Settings, then press the

SELECT soft key.

Press repeatedly the navigation keys to

SELECT

choose 1.Service Ctr1 or 2.Service Ctr2, then

press the SELECT soft key.

Enter the service number using the numeric

keys. You can enter up to 24 digits.

Press the OK soft key to save the setting.

To return to Standby mode, press the end/on/

off key.