Installing/Removing Main Memory - Fujitsu D2721 Kurzbeschreibung

Brief description of mainboard

Installing/removing main memory

Technical data
Technologie
Gesamtgröße
Modulgröße
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://ts.fujitsu.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-5300U or PC2-6400U specification.
If you use more than one memory module, make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded. When inserting the memory
modules, start with the slot furthest away from the processor (slot 4).
With a memory configuration of 4 GB the visible and usable main memory can
be reduced to 3.5 GB (depending on the system configuration).
More than 4 GB of main memory can only be used with a suitable operating system.
slot to be used
Channel A, slot 1
Channel B, slot 2
Channel A, slot 3
Channel B, slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
4 - English
DDR2 667 / DDR2 800 ungepufferte DIMM Module 240-Pin; 1,8 V;
64 Bit ohne ECC
128 MBytes bis 8 GByte DDR2
128, 256, 512, 1024 oder 2048 MByte pro Modul
Channel A
Channel B
Channel A
Channel B
Number of inserted memory modules
1
x
1
2
3
4
2 3
x
x x
x x
A26361-D2721-Z210-1-8N19, edition 1
4
x
x
x
x