Installing/Removing Main Memory - Fujitsu D3011 Bedienungsanleitung

6 - English

Installing/removing main memory

Technical data
Technology
Total size
Module size
A current list of the memory modules recommended for this mainboard is available
on the Internet at: "http://ts.fujitsu.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may use only unbuffered 1.5 V memory modules without ECC.
DDR3 memory modules must meet the PC3-6400U or PC3-8500U specification.
If you use more than one memory module, then make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
Maximum system performance is achieved when identical memory modules
are used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
With a memory configuration of 16 GB, the visible and usable main memory may
be reduced to 15 GB (depending on the system configuration).
Slot to be used
Channel A, slot 1
Channel B, Slot 2
Channel A, slot 3
Channel B, Slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
24
All manuals and user guides at all-guides.com
DDR3 800 / 1600 unbuffered DIMM modules 240-Pin; 1,5 V; 64 Bit,
no ECC
1 GB to 16 GB
1024, 2048 or 4096 MB per module
slot 4
Channel B
slot 3
Channel A
1
x
Installing/removing main memory
Number of memory modules inserted
2
x
x
slot 2
slot 1
3 4
x x
x x
x x
x
Fujitsu Technology Solutions