Installing/Removing Main Memory - Fujitsu SIEMENS COMPUTERS D2317 Kurzanleitung

Installing/removing main memory

Disconnect the system completely from the mains voltage before performing any of the
tasks described below. Details are contained in your systems' operating manual.
Technical data
Technology DDR2 533 / 667 / 800 unbuffered DIMM modules 240-Pin; 1.8 V; 64 Bit, no ECC
Total Size 128 Mbytes to 8 Gbytes DDR2
Module size 128, 256, 512, 1024 or 2048 Mbytes per module
A current list of the memory modules recommended for this mainboard is available on
the Internet at: "www.fujitsu-siemens.com/mainboards".
At least one memory module must be installed. Memory modules with different
memory capacities can be combined.
You may use only unbuffered 1.8 V memory modules without ECC.
DDR2-memory modules must meet the PC2-4200U, PC2-5300U or
PC2-6400U specification.
If you use more than one memory module, make sure to distribute the
memory modules over both memory channels. By doing this you use the
performance advantages of the dual-channel mode.
The maximum system performance is given when the same memory size
is used in Channel A and Channel B.
To simplify equipping, the slots are colour coded.
With a memory configuration of 8 Gbytes the visible and usable main memory can be
reduced down to 7 Gbytes (depending on the system configuration).
slot 4
slot 3
Slot to be used
Channel A, slot 1
Channel A, slot 3
Channel B, slot 2
Channel B, slot 4
The installation/removal is described in the "Basic information on mainboard" manual.
A26361-D2317-Z110-1-8N19, edition 2
Installing/removing main memory
Channel B
Channel A
Number of inserted memory modules
1 2
x x
x
slot 2
slot 1
3 4
x x
x x
x x
x
English - 5