Addressing; Connection With The Mains; Operation; Stand Alone-Mode - EuroLite LED WMB-830 RGB Bar Bedienungsanleitung

Addressing

Define the DMX starting address via the control board.

Connection with the mains

Connect the device to the mains with the enclosed power supply cable.
The occupation of the connection-cables is as follows:
Cable Pin
Brown Live
Blue Neutral
Yellow/Green Earth
The earth has to be connected!
If the device will be directly connected with the local power supply network, a disconnection switch with a
minimum opening of 3 mm at every pole has to be included in the permanent electrical installation.
The device must only be connected with an electric installation carried out in compliance with the IEC-
standards. The electric installation must be equipped with a Residual Current Device (RCD) with a maximum
fault current of 30 mA.
Lighting effects must not be connected to dimming-packs.

OPERATION

After you connected the effect to the mains, the EUROLITE LED-bar starts running and indicates the last
operating mode on the display.

Stand Alone-Mode

1. Chaser
A chaser is a sequence of different steps that will be called up one after another in a continuous loop. With
LED WMB-bar, you can select up to 16 different chasers.
Selecting a chaser
To define the starting address press MODE until the display indicates
"A001". The appropriate LEDs light up.
Set the address via the UP- and DOWN buttons.
International
L
N
Press the MODE button until the appropriate LED (AUTO) lights up on the
display.
Now, select the desired chaser (Pr01 – Pr16) via the UP or DOWN buttons.
Press the MENU button, to adjust the speed (S) between 80ms/step ~ 5s/step
and brightness (d) between 0-100%.
Use the UP or DOWN buttons to set the values.
21/28 51930310_V_1_0.DOC