Setting The Time - Medion LIFE P62033 Bedienungsanleitung

MODE - change operating mode
 Press the MODE button to switch between radio reception and media playback
(CD, USB, etc.). The operating mode selected will be shown in the display.
Radio reception
Playback from the CD drive
Playback from USB connection
Playback from SD card
Play an external audio device
DSP - display additional information
 You can change the screen display by pressing the DSP button repeatedly. Each
message appears for just a few seconds.
Operating mode
Radio mode with Radio Data Sys-
tem reception
Radio operation without Radio
Data System reception
CD/USB or card operation
NOTE!
The PTY functions are sent in differing scope by different stations; see
also chapter "Radio Data System" on page 72.
If no RDS or PTY information is received, PTY NONE is displayed on
the screen.
If no frequency is received, PS NONE is displayed on the screen.

Setting the time

After switching on for the first time or after pressing RESET, the time resets itself
automatically when receiving a channel using the Radio Data System .
Proceed as follows to set the time manually:
 Call up the time.
 While the time is displayed hold down the DSP button. The time indicator flash-
es.
 Turn the dial/button to the right to set the hours and to the left to set the min-
utes.
 To save the new time, press the DSP button again or wait until the display re-
sets.
70 of 86
84003 DE EN eCommerce Content final REV4.indb 70 84003 DE EN eCommerce Content final REV4.indb 70
Operating mode
Programme name > "CT" (clock time) time >
frequency > PTY settings
Frequency > "CT" (clock time) time > PTY set-
tings
"CT" (clock time) time for around 5 seconds
RADIO
DISC
USB
CARD
AUX
Display additional information
Display
28.05.2015 09:09:19 28.05.2015 09:09:19