Installation And Initial Use; The Iso Slot; Fitting The Mounting Frame In The Iso Slot - Medion LIFE P62033 Bedienungsanleitung

6. Installation and initial use

DANGER!
Disconnect the minus pole from the car battery before in-
stallation!
There is a risk of short-circuit and electric shock!
6.1.

The ISO slot

The car radio has been designed for installation in a standard ISO installation slot. It
must measure at least 53 x 182 mm.
The ISO slot normally has two ISO sockets and one antenna socket.
NOTE!
If your vehicle does not have an ISO slot or the corresponding connec-
tions, the cable sockets supplied can be used. Contact your specialist
workshop, retailer or departments in department stores. See also sec-
tion "8. Information on the cables" on page 64.
6.2.

Fitting the mounting frame in the ISO slot

CAUTION!
Follow the safety instructions for installation on "4. Installa-
tion" on page 53.
 Before installation, always remove the two transportation safety screws in the
top radio casing (recognizable by a red flag)!
On delivery, the mounting frame (1) is pulled over the car radio (2). First remove the
mounting frame from the casing of the car radio.
84003 DE EN eCommerce Content final REV4.indb 59 84003 DE EN eCommerce Content final REV4.indb 59
182 mm
53 mm
59 of 86
28.05.2015 09:09:05 28.05.2015 09:09:05
DE
EN