7.5.
Removing the unit
To dismantle the unit, first remove the control panel and then the cover frame.
Insert the left and right keys into the relevant slots on the sides of the device.
The flaps will be bent back and you can remove the unit.
8. Information on the cables
NOTE!
The information on the cables is to be used if the cables are to be routed
individually. To do so, contact a specialist workshop and hand over the
ISO plug supplied and the information from this section.
You do not need the following information to connect the radio to the
ISO plugs in your vehicle.
Two ISO connectors with cables are supplied:
•
Connector with electric cables for ISO socket block A
•
Connector with speaker cables for ISO socket block B
8.1.
Overview of ISO socket A: power
64 of 86
84003 DE EN eCommerce Content final REV4.indb 64
84003 DE EN eCommerce Content final REV4.indb 64
5
7
4
8
Red: Ignition lock (switched plus)
Black: Earth
Blue: Power output antenna
Yellow: Memory Back-Up (permanent plus)
Terminal 15
12 V+
Terminal 31
Terminal 30
12 V+
28.05.2015 09:09:13
28.05.2015 09:09:13