Sharp XV-Z2000 Anleitung Seite 30

XV-Z2000
DT-400
* Precautions in setting up the DMD (Digital Micromirror Device) unit
Before connecting the formatter PWB to the optical engine, take the following steps. Look at the voltage rank marking
that is on the DMD itself. Referring to this marking, set the DIP switches on the formatter PWB. And connect this PWB
to the optical engine. Wrong settings will adversely affect the system performance.
Set the formatter PWB switches according to the Bin voltage shown on the back face of the DMD.
2-Dimensional Matrix Code
(DMD Part Number and
Serial Number)
Part 1 of Serial Number
(7 characters)
TI Intenal Numbering
YYYYYYY
*1272-6bbc
CHXXXX L LLL LM
LLLLL
TI Intenal Numbering
1
The last alphabet letter indicates the
Bin voltage setting (D. E).
2Based on Bin voltage, switch is set up as follows.
D:
E:
30
DMD Part Number
Part 2 of Serial Number
(6 or 7 characters)