Traction Battery Compensation; Use As A Power-Supply; Use Of A Temperature Sensor - Victron energy SKYLLA-TG 24/80 Gebrauchsanweisung

4.5

Traction battery compensation

If a Traction-battery is connected to the Titan charger the charge
voltages have to be changed. The output voltage has to be raised to
correctly charge the traction-battery. It is possible that the charge
voltages are not correct after activating this compensation. See for
adjusting the charge voltages chapter 4.2.
To set the charger into the traction mode:
Place DIP-switch 3 "trac" to the left.
4.6

Use as a power-supply

The Titan charger can be used as a power supply without the obligation to connect a
battery to the charger output.
To use the charger as a power supply:
Put the charger into the permanent boost-charge mode, see chapter 4.1.
Adjusted the output voltage to the desired voltage, see chapter 4.2.
With the above mentioned procedure the output voltage range is limited. When the full
output voltage range is required please contact your Victron Energy dealer. See chapter
6.3 for details.
4.7

Use of a temperature sensor.

The temperature sensor supplied with the charger can be
connected to the charger by using the 3 meter cable with
stripped and tinned cable ends. This sensor should be
mounted on the battery. The temperature sensor adjusts
the charging voltage according
temperature.
To connect the temperature sensor:
Disconnect the mains,
Connect the - (black wire) of the temperature
sensor to the "-tmp" connector, see illustration 8.
Connect the + (red wire) of the temperature sensor
to the "+ tmp" connector, see illustration 8.
Switch on the mains.
If the temperature sensor is correctly connected the
"TMP OK" on the printed circuit board led
illuminates. If this led does not illuminate or
flashes, the sensor is not connected correctly.
20
to the battery
Illustration 8.
Location of the external connections.
Manual Titan